Board Configuration

  • Nucleo-F302R8

    Control Board

  • X-Nucleo-IHM07M1 3Sh

    Power Board

Control Board

Step 1

  1. Remove jumper JP1.
  2. Plug-in jumper JP5 as shown for power supply from USB connector of ST-LINK/V2.
  3. Check that LD3 is turned ON.

Step 2

  1. Plug-in the two jumpers on CN2, to program the STM32.

Recommendations

  1. Use the external Isolated ST LinkConnect using HIGH VOLTAGE Power Board.

Power Board

Step 1

  1. Plug-in jumpers J5 and J6 as shown for three shunt configuration.

Step 2

  1. Remove jumper J9.
  2. Plug-in jumpers JP1 and JP2 as shown.

Connectors

  1. J1 Power supply connector.
  2. J2 Motor connector.